Roger Technology BIONIK 6 super-intensive barrier

High-speed brushless barrier Bionik 6

BI / 006 < /span>

BIONIK - an ultra-intensive barrier with a boom up to 6 m and a 36 V DC brushless electric motor with a built-in control unit and boom position sensors.

< strong> Gear motor

The gearbox housing is made using precision injection molding technology. All gears are made of metal. The worm gear is made of hardened steel and bronze. The shafts are installed in bearing supports.

Durable construction

In order to increase reliability, all power The barrier's structural elements are made of steel and bronze. Life tests and high quality manufacturing ensure trouble-free operation of the equipment over a long service life.

LED lighting

Signal lighting is made using bright LEDs , which are located at the top of the barrier. The glow algorithm is set by the control unit.

Control block

Fine-tuning the barrier modes is done using digital control unit. For ease of setup, the control unit is located at the top of the barrier.

Elliptical arrow

Boom profile - ellipse with stiffeners . Boom material is aluminum. LED indication can be integrated into the boom profile. The glow algorithm is set by the control unit.

Perfect transfer

All gears of the barrier gearbox are produced only in by Roger Technology and are made of steel and bronze. The transmission uses reliable, low-noise gears with a tooth angle of 15°.

Fine-tuning

The boom end positions are adjusted with extreme precision thanks to the digital control unit

Innovative unlocking

Thanks to the original design of the unlocking mechanism, switching the barrier to manual mode can be done effortlessly at any point.

Balancing spring

The balancing spring model is selected depending on the boom length. All Roger Technology springs are certified for 1,000,000 cycles. A system for fine-tuning the spring is provided.

Brushless 36V

Innovative revolutionary 36 V digital brushless motor with constant magnetic field in combination with a digital control unit allows you to significantly reduce power consumption. < /span>

Encoder

A special encoder installed on the output shaft of the gearbox allows, after turning off the power or switching to manual operation, to resume operation barrier without carrying out configuration procedures.

Boom attachment

The barrier boom is attached to the gearbox shaft using original fasteners developed by Roger Technology, which reduces vibration during movement arrows.